MODCHIP EMULATOR!!! ISO DAL PC con XP e il CAVO attaccato al Wii

MODCHIP EMULATOR!!!
Caricare ISO dal PC con XP e un cavo nel Wii

AloneTrio ha rilasciato il PRIMO "modchip emulator" per il Wii e il PC.
Usando l' Erant Serial DVD cable, puoi giocare i backup del tuo Wii dal PC.

Ora l'archivio contiene pure l'exe!!!!

download WABMODCHIP.rar

quote:

Here is the so Awaited WAB-ModCheap Launcher for D2B WII VERSION

1/ turn ON your WII
2/ run WabModcheap(.exe)
3/ Insert disc when it ask
4/ Play

+ __________________________________________________ ______________ +
Notes :
- Cheap DVD-R sux sometime, if the game doesn't start
and stop spinning eject it and reinsert it !!

- This code DONT USE WIINJA CODE !!

- This CODE IS OPEN SOURCED

- EXE win32 compiled version by Jurai

- FULLY TESTED UNDER LINUX WORK 100%

+ __________________________________________________ ______________ +
Important NOte :

For CINDY KATE : Hey Girls !! Where Are you ???
4gn3s : Thanks for All...
KpHLight : Thanks to your inspiration
Xorloser : Sorry For lastest release
MRsporty : Same...
rhcp : Go to Hell with your bullshit....
#wiidev : Hi all, Fuck Op
Wab Fans : Next Release is on the Way


MAKING THE DATA CABLE:

In order to make the datacable, you need only a few basic items. A DB-25 connector, two diodes, and some cable. Connect the diodes in reverse (so, PC ---|<--- Wii) to the DB-25 connector, to pins 1 and 14. Just connect some wires to pins 18 and 11, these will be the GND and output wires. The other two dioded wires are clock and input. Now, open your Wii, remove the DVD drive, and turn it over. Look for the following pattern near IC3001 (http://wiire.org/Wii/console/disc_drive):
- 1 - 2 3 4 - 5 6 3 is SBO1 (Output) 4 is SBT1 (CLK) 6 is SBI1 (Input) With the numbers being pads, and - being nothing. Now, solder the wire from pin 1 to pad 4 (CLK line). Pin 14 goes to pad 6, and pin 11 goes to pad 3. Just find a suitable place to attach the wire from pin 18, which is GND. (Placing the board so you can read the writing on IC3001, look at connector P3001, the rightmost pad is GND and the third from the right is GND).
Check your solder connections with a multimeter, then close up your Wii

more.. http://forum.wiibrew.org/viewtopic.php?t=22
more.. http://wiire.org/Wii/console/disc_drive):